So, after spending some time searching on the web how to do the guides for my table saw I came out with this design, very similar to the commercial jigs from Microjig. Unfortunately those one are not suitable for my table saw and probably too expensive for my wallet. So why do not give a try to my new Creality Ender 3?? There you go.. after 2 hours of printing I finally tried them and work just fine! Unfortunately I forgot to put the holes for the sled attachment but I added them afterwords and now I am printing a bunch of guide!! The slicer software says that it will take 10 hours, so I’d better go to sleep and wait until tomorrow.

If everything goes well tomorrow I will upload the models on thingiverse!

Stay tuned

Max